Alternation Relay for central 2 motors and alarm RA25A

VER PREÇO / COMPRAR




Product Name Price Delivery Qty
Alternating Relay RA25A, 24V AC/DC
Cód.17225111
€53.88
Alternating Relay RA25A, 230V
Cód.17225112
€53.88

Product Description

RA25A Multifunction Toggle Relay

Alternation command for hydropressor plant or effluent plant with 2 electric pumps + alarm.

Operation
If one of the options for hydropressor plants (PAB or PAS) is selected, and there is water in the reservoir, indicated by the lack of water alarm command (6-9) closed, whenever the alternation command (6-8) closes, the output relays (1-3) and (1-4) arm alternately. If the simultaneity command (6-7) also closes, the relay causes the two outputs (1-3) and (1-4) to remain closed simultaneously. If this command reopens, nothing changes, the two output relays remaining closed until the alternation command (6-8) opens. Whenever the high level alarm command (6-11) closes, the alarm output (1-5) is activated. If there is no water in the tank, the two outlets (1-3) and (1-4) remain open. If the lack of water alarm command (6-9) is implemented by float, when the water is restored, the relay allows outputs (1-3) and (1-4) to arm immediately, if implemented by probes, the relay only allows outputs (1-3) and (1-4) to arm after 4 minutes.

If one of the options for effluent plants (WA or WAT) is selected, whenever the stop command (6-9) and the alternation command (6-8) close, the output relays (1-3) and (1-4) arm alternately, only turning off when the stop control (6-9) opens. If the simultaneity command (6-7) closes, or in the option with timed simultaneity command, if the toggle command (6-8) is closed for a time greater than 10 minutes, the relay causes both outputs ( 1-3) and (1-4) remain closed at the same time. If any of the alternation (6-8) or simultaneity (6-7) commands reopen, nothing changes and the two output relays remain on until the stop command (6-9) opens. If the high level alarm command (6-11) closes, the alarm output (1-5) is activated.

In any of the operating modes, in the event of failure of some of the controls, the relay allows alternative operation, as a way of avoiding blocking the entire system.

In order to avoid hydraulic shocks, the relay has a device that delays the cut-off or start-up of the second electric pump by approximately 2s, even if the simultaneity command has been carried out together with the alternation command.

Documents

For more information, see the Technical Data Sheet

Partilhe